Threadless jewellery uses tension between the end and the shaf to fit and stay together. The end has an insertion pin which is slightly bent when inserted into a straight shaft. This slight bend of the pin against the straight shaft creates spring tension, holding the end securely in place.

Please see instruction below:

1. Prepare the pircing
2. Insert the pinone-third to halfway into the shaft.
3. Slightly hand-bend the insertion pin against the shaftas shown. Please note: Over bending could make the fit too tight.
4. Push the end into the shaft and test the fit.

Adjusting the fit:

If it is too tight, take some of the bend out of the pin and try again. Remember adjustslightly and then try again.